Everything I can acquisition explains how to install this affectionate of bank just on the lower bisected of the wall. I wish to install it floor-to-ceiling, and I'd like something to go off of. Specifically, I wish to apperceive how to section it calm the appropriate way because the bank is usually awash in 4' alpine panels, and my beam is slanted up to about 15'.

Answers :Are you adage that the walls are 15' tall? Or are the walls 8' tall, and again it is addition 7' to the accomplished point of the ceiling?
It sounds as if you accept a basilica ceiling, and that you wish to console the 2 "end" walls, the ones that attending like a rectangle with a triangle on top (the gable end walls).
It would be bigger to use some 8' alpine paneling. Again you would assemblage addition section of bank on top of the 8' panel. There is a section of trim that goes amid the ample panels. From the end, the trim looks like the letter "H". The basal bisected of the "H" is slid assimilate the top of the lower section of paneling; then, the top section of bank is slid into the top bisected of the "H". Sound confusing? Achievement not...
When you go to your home center, you'll see the trim next to the paneling, and it will all click.
Press on, accomplishment up, be proud

Answers :I achievement you are absent to install 4' x8' panels and not the alone boards.
First abolish all baseboard trim, aperture trim , awning plates on switches,outlets, pictures, aggregate on walls.
Now admeasurement out 48" from bend angular on wall. Put a mark here. Now you charge to acquisition copse stud bandage about from this 48" mark and the corner. Either acquirement a studfinder or yield an 6d accomplishment attach and alpha on the 48" mark and drive the attach through the drywall (about) 1/2" to acquisition the stud. Go in about 1/2" increments from your 48" mark alive against the corner. Once you acquisition the stud - get a little added abundant and locate the center. Now yield a akin and erect (mark vertical line) from basal of bank to top.
This is area your aboriginal area branch bend will be. Cut ancillary of console will go in corner, branch bend on this line.
Plumb and install all lower sheets, aural 1/4" akin forth the tops. Cut and assemblage high bedding lining up edges to accumulate grooves the same. Install a bandage abstraction accumbent over the base joints area panels meet. Attach off all bedding on 16" centers - use console adhering alone as bare - it charcoal drywall should you anytime wish to abolish panels, application and acknowledgment to drywall corrective walls. If you were talking about bean lath planking, you will charge to cement it on, as the axle widths will sometimes abatement amid studs and you will accept annihilation to adhere them into. Attending at 4' x8' panels edges carefully as they are sometimes a little different. They are fabricated to alone adjust one way to accord the collective the aforementioned beaded attending as the chaplet in the centermost of the panel. This helps the vertical console joints dissappear as they attending like all the chaplet on the average of the panels.

Perhaps a impaired catechism but......
I purchased a babyish olive bulb the added day and wondered if it will eventaully abound to an olive tree.
Can anyone explain to me the aberration amid an olive bulb and an olive tree? I anticipation the olive bulb was just the aboriginal years of an olive tree. Anyone able to clarify?